iSensor Patio

Please search and download "Amaryllo AI" APP to get started.

★ Make sure your smart phone is connected to the same Wi-Fi network

1. Connect the (micro) USB cable to a power outlet.
2. The blue LED light will illuminate when the device is powered on.
3. Wait for it to start flashing before beginning installation. After
4. power-on, it will take 25 seconds to start calibration cycle.

Select Koova in the APP then follow the instructions shown.

★ Please refer to the FAQ page for more info on how to share the viewer or administrator rights to other smart phone devices.

1. Please make sure that your smart phone is connected to the same
   Wi-Fi SSID network.
2. After selecting Koova, you will be given Internet setup options.
3. Select Auto-Detection (Recommended)

Tap on the AMID to complete auto setup.

Note: AMID can be found on the bottom of the device. Make sure the AMID is the same as one which appears in APP setup.

Congratulations! Your iSensor Patio is set up and ready to go.

Note: The camera is designed for easy DIY installation but if you need local assistance, please visit www.SoteriaAi.com to locate a
professional installer near you.

★ Please be sure your device is running on the latest firmware.

• Switch on your phone’s Wi-Fi. Connect your phone to a router.
• Enter the password of your Wi-Fi router. 
• Your device will automatically generate a QR code.
• Place the device 4” ~11.8” (10~30 cm) in front of the QR code or 7.8” ~11.8”
  (20~30 cm) in front of tablet’sQR code. 

Please wait for a beep to confirm reception. After you hear a beep, you can put the phone down.

★ Make sure your portable device and the device are parallel to each other.

Blue LED

• The LED is stable when you power on the device. The LED flashes once per second when the QR scan is in progress.
• When LED is flashing twice per second, the device is in use and someone is actively viewing it.
• When LED is flashing 3 times per second, the setup process was successful.

Green LED

• When LED is flashing once per second, the device is trying to connect to a Wi-Fi AP router.
• When LED is constant, the device is connected to Wi-Fi and working properly. 

• First, make sure the device is powered on and the calibratio is completed.
• There is a small RESET hole. Press and hold for about 5 seconds until the blue LED flashes. All settings of previously stored in the device will be erased, and it will be restored to the factory default.
• After 25 seconds, the device will start a calibration mode by rotating itself. (for remote models)

1. Connect your phone to your router.
2. Press and hold the router’s WPS button.
3. Press and hold WPS  button on the device for 5 seconds or longer. When the green LED flashes, it indicates that the device has entered WPS mode.
4. Please follow App instructions step-by-step.

Note: You need to press WPS button of the device and Wi-Fi AP router within 60 seconds. (Using a paper clip)

• 32 ~ 95°F (0 ~ 35°C) indoor use only
• Prolonged exposure to direct sun and moisture is not recommended. 
• Patio should be placed under shaded area and avoid direct rain or snow.

1. Choose a location that will offer you the best viewing angle. Make sure that an electric outlet is within 2 meters. 
2. Use a pencil to mark the hole locations. Make sure holes are slightly smaller than anchors.
3. Insert anchors to wall and secure holder to wall with screws.

Please scan the QR code to obtain more info on our Terms of Use.

★ Need help? Visit http://www.amaryllo.eu/support or drop us an email with photo or video and description of the problem to support.ai@amaryllo.eu

★ Warranty is voided if camera is dissembled.